The basket occasionally went in the dishwasher which cleaned the surface, but the well gunked grease has been building up.

Tried soaking the basket in soap and hot water. Scrubbing with a soft sponge. And then running the dishwasher multiple times but it only got a small part of the grease out.

  • pcr3@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    3 hours ago

    Post a picture of it, the basket and the mesh.

    If it’s really bad then like someone else suggested: get some oven degreaser from the store, spray it down, let it sit for 10 minutes and wash off with hot water. Try not to breath the stuff, it’s nasty.

    But you should be cleaning it weekly. Warm it up for a minute or two, then with folded paper towels wipe it out over a trash can. Leaving a light coating is actually to your advantage, it will keep the new stuff from sticking.

  • tonyn@lemmy.ml
    link
    fedilink
    arrow-up
    35
    ·
    19 hours ago

    This is probably going to be an unpopular opinion, but here it is anyway. If it doesn’t come off with dish detergent and a scrub sponge, just call it a permanent seasoning and let it be. If scrubbing it like mad won’t make it come off, then it won’t come off if your food touches it.

  • DannyBoy@sh.itjust.works
    link
    fedilink
    English
    arrow-up
    4
    ·
    edit-2
    12 hours ago

    Hand wash with soap after each use? What are people saying in the comments about built up residue or oil?

  • ragebutt@lemmy.dbzer0.com
    link
    fedilink
    English
    arrow-up
    5
    ·
    16 hours ago

    Is it teflon coated? If so you should be careful. Many of the suggestions here are for increasingly abrasive options which will scratch that coating and cause it to eventually flake off, which means it will get into your food, which definitely not something you want to eat

    On one hand the grease itself is probably not a food safety issue anymore. Similar to a cast iron pan once oil/grease heats enough on a surface it polymerizes and essentially bonds to the surface. This is generally safe unless the oil is exposed to very high temps (beyond what is typically used for cooking) but it looks bad on stuff like sheet pans

    However you do want to be a bit more diligent cleaning as a result. Unlike a cast iron pan where the polymerization layer (seasoning) is generally very smooth this is generally not; it is bumpy and has more nooks and crannies. This means there are more areas where filth and bacteria can be harbored. Not a huge issue, just make sure you clean well.

  • Uranium 🟩@sh.itjust.works
    link
    fedilink
    arrow-up
    16
    ·
    edit-2
    22 hours ago

    Silly suggestion, and no idea if it will work, but it’s an easy one to test;

    Get some cooking/vegetable oil, and see if it will help dissolve the residue by putting a bit on some kitchen towel and either scrubbing with the oiled paper towel or leaving that towel on the residue for 10 mins and seeing if the grease has softened.

    If the oil does seem to dissolve/soften the grease residue then you can add some bicarb/salt to act as gentle abrasive as it won’t dissolve in the oil as it would do in water

    I’ve used cooking oil to dissolve tar/bitumen paint from my skin and clothes before and you can then use soap to clear the dissolved tar in oil.

    Otherwise use a kitchen degreaser like you’d clean a traditional oven with.

    I imagine what’s happening with the oil is something akin to polymerization, so you either need to break the polymers bonds or dissolve in a suitable solvent

      • SergeantSushi@lemmy.world
        link
        fedilink
        English
        arrow-up
        2
        ·
        7 hours ago

        Soak the basket in 50% vinegar: water. Then run the air fryer with some vinegar in it to clean out the rest of it.

        Vinegar is an acid which works great on grease. Baking soda is basic and works great on carbon build ups.

    • OneOrTheOtherDontAskMe@lemmy.world
      link
      fedilink
      arrow-up
      5
      ·
      18 hours ago

      Not silly, that’s a common cleaning technique from janitor/cleaning staff i was told a while back. Use a little bit of what causes the stain/gunk and it helps break down the bonds by binding with the already-solidified object and trying to mix with it, weakening/changing the concentration of the ‘stuck’ substance

    • EchoCranium@lemmy.zip
      link
      fedilink
      English
      arrow-up
      5
      ·
      21 hours ago

      I do this with ours. Spray it and let sit for at least half an hour in the sink. Hose off the caustic with hot water, then nylon brush the residue.

      • MNByChoice@midwest.social
        link
        fedilink
        arrow-up
        8
        ·
        21 hours ago

        Hose off the caustic with hot water

        Wear eye protection if truly hosing. You don’t want that shit in your eye.

  • Izax@pawb.social
    link
    fedilink
    English
    arrow-up
    5
    ·
    19 hours ago

    Try soaking it again overnight but with dishwasher detergent instead of normal dish soap

  • jet@hackertalks.com
    link
    fedilink
    English
    arrow-up
    8
    ·
    edit-2
    21 hours ago

    Maybe a good soak in vinegar, then alcohol

    Most of what I know about grease comes from industrial machinery. Maybe it doesn’t transfer over well. Steam is also a good option.

    When fats get to high enough temperature they polymerize, on cast iron we call it seasoning. If you let the grease build up, and go through many cooking cycles your actually trying to get rid of polymers

  • BlueSquid0741@lemmy.sdf.org
    link
    fedilink
    arrow-up
    7
    ·
    22 hours ago

    I clean mine by soaking in hot water and scrubbing with a nylon bristle dishwashing brush. I don’t have a dishwasher. This is working great, but the key is I’m doing it after every 2nd or 3rd time I use the air fryer.

    It’s a new one, we had to throw our old one out because we didn’t wash it well enough and it gunked up so badly it was almost unusable and started smoking whenever you turned it on.

    I did get the gunk off with thorough scrubbing but it damaged the shit out of the non stick coating, we weren’t gonna risk using it like that.

    Taking real good care of the new one.

    • Gamma@beehaw.org
      link
      fedilink
      English
      arrow-up
      2
      ·
      13 hours ago

      We try to clean ours every time and got a few little boat things to keep the mess down. Looks brand new half a year later

  • Sonor@lemmy.world
    link
    fedilink
    arrow-up
    6
    ·
    21 hours ago

    I could never fix my gunked up old one. I tried dishwasher, hot water, store brought anti-grease soap or what, nonthing. Had to yeet it. The new one i wash religiously and after a round in the dishwasher, i scrub it down before using it. I’m afraid your old one might be beyond help

    • simple@lemm.ee
      link
      fedilink
      English
      arrow-up
      5
      ·
      21 hours ago

      Same here. If you build up layers of oil and stuff on the basket it’s never coming out. It’s not a big deal IMHO.

  • wewbull@feddit.uk
    link
    fedilink
    English
    arrow-up
    5
    ·
    21 hours ago

    I preheat the air fryer to soften the fat and oils. Drain whatever I can into a container, and use a silicone spatula to get anything that is still adhered.

    It then goes in the dish washer on a hot wash. Come out like new.

  • space_of_eights@lemmy.ml
    link
    fedilink
    Nederlands
    arrow-up
    1
    ·
    17 hours ago

    Try this: slice a lemon in half. Put it in a heat-resistant bowl. Place bowl into airfryer and set at 200 Celsius for 20 minutes. It’ll probably smoke, so make sure to ventilate well.

    After that, you may be able to wipe most of the grease away with a cloth.